4. Feed the backing paper through the lower opening of the exit cover. Close the exit cover. Pull down on the backing paper to remove any slack.
Peel
Bar
Lower |
|
|
|
|
|
|
|
| |
Opening |
|
| Tear | |
|
|
| Edge | |
| ||||
|
|
|
|
|
|
| Backing |
| |
|
|
| ||
|
| Paper |
| |
|
|
|
|
|
When removing the backing paper, pull up across the
5. Close the printer's cover.
6. Press Feed/Cut several times to feed at least three labels/tags to properly position the supply and the ribbon.
A d j u s t i n g t h e W i d e / N a r r o w K n o b s
You may need to adjust the two wide/narrow knobs according to the width of your supply. For supply that is more than two inches, adjust the knobs to the wide setting. For supply that is two inches or less, adjust the knobs to the narrow setting.
You must adjust both of the knobs to the same position.
If you experience ribbon smudging in cold, dry environments, adjust the wide/narrow knobs to the wide setting.
For wide supplies, push down and turn the
wide/narrow knobs clockwise with a screwdriver.
For narrow supplies, turn the wide/narrow knobs
The adjustment is shown in the wide position.
Wide/Narrow Knobs
8
