Paxar 9855 RFID manual Push down on the supply lever to unlock the supply guides

5. Adjust the supply holder guides so the sides barely touch the roll. Make sure the supply roll turns freely.

If you are using fan-fold supplies, place the supply stack behind the printer, label side facing up.

Supply Holder Guides

6. Push down on the supply lever to unlock the supply guides.

7. Lay the label strip across the supply guide so that a few inches extend past the front of the printer. Tuck the supply under the nibs and in between the die cut sensor. Do not feed supply between the supply roller and deflector.

For fan-fold supplies, lay the label strip over the supply holder and across the supply guide so that a few inches extend past the front of the printer. Tuck the supply under the nibs and in between the die cut sensor.

8. For tag supplies using the optional knife, feed the supply through the knife. Make sure at least 0.5 inches of supply is past the knife.

Tag

5