For |
|
strip over the supply holder and |
|
across the supply guide so that a | Nibs |
few inches extend past the front of |
|
the printer. Tuck the supply under | Supply |
the nibs on the supply guide. | |
| Lever |
7.Adjust the supply guides so they touch the supply. Push up on the
supply lever to lock the supply | Thumb Well |
guides into place. |
|
8.Hold the printhead assembly by the printhead tab while pressing down on the printhead release.
9.Close the printhead by pressing
down on the thumb well until you hear it click into place.
10.Close the cover.
11.Press Feed to position the supply under the printhead.
You may need to adjust the wide/narrow knobs depending on the width of your supply. See "Adjusting the Wide/Narrow Knobs" for more information.
If the printer will be unused for extended periods of time, we recommend leaving the printhead unlatched.
F o r P e e l M o d e :
The minimum feed length is 1.5 inches for peel mode. You must use
Load supplies as shown above. Follow these steps after you close the printhead.
1. Remove the labels from the first
10 inches of the backing paper.
2. Press down on the exit cover tabs to open the exit cover on the front of the printer.
4
