Paxar Monarch 9805 manual I n t i n g a Te s t L a b e l

5.Lift the printhead assembly using the printhead tab and push back until the printhead assembly clicks into place.

6.Carefully unplug the cable from the printhead as shown.

7.Carefully plug the cable into the new printhead.

8.Align the new printhead with the tabs.

9.Snap the printhead into place. Make sure the printhead cable does not touch the ribbon roll.

10.Clean the new printhead with a cotton swab dipped in isopropyl alcohol to remove any salt or oil left from handling.

Do not touchhere

P r i n t i n g a Te s t L a b e l

Press Pause and then press Feed. The label shows the model number, software version, stock count, voltage, print contrast, printhead resistance, communication settings, ENQ characters, and code page selection.

If using on-demand mode, a test label prints only

after all labels in the batch are printed and

removed.

If you turn off the printer, you must wait 10-15 seconds (until the power light is completely dim) before turning it back on; otherwise, an error occurs.

11