Paxar Monarch 9805 manual E a r i n g L a b e l J a m s, E a n i n g, Platen Roller Supply Sensor

C l e a r i n g L a b e l J a m s

If a jam occurs, the Supplies light on the printer’s front panel blinks.

1.Turn off the printer. Open the cover and printhead assembly.

2.If necessary, remove the label roll and ribbon.

3.Remove the jammed labels and reload the label roll.

4.Close the printhead assembly and turn on the printer. Press Feed to position the supply under the printhead.

C l e a n i n g

You may need to clean the printhead and platen roller:

uwhen there is any adhesive build-up in the supply path

uafter printing approximately 8 rolls of supply, after using two ribbons, or whenever you load new supplies

uwhen you see voids in the print.

CAUTION

Do not use sharp objects to clean the printhead. This may

damage the printer and void your warranty.

1.Turn off the printer.

2.Open the cover and printhead assembly.

3.Remove the label roll and ribbon (when cleaning the printhead).

4.Press down on the exit cover tabs to open the exit cover on the front of the printer.

5.Clean the platen roller with a dry cloth or small brush. However, if there is adhesive gum build-up on the platen roller, moisten a cotton swab with isopropyl alcohol. Turn the platen roller with your finger and run the

Platen Roller

Supply Sensor

9