Pelco C1621M-E (9/08) 3 manual Desktop Installation

3.Peel away the backing of the small label and attach it to this installation manual, other product documentation, or an unobscured product location.

				Text
				ple
			V m
			RE	Sa
				t
		0	S	Tex
		0	L ple
Model		2	T
		2	O m
		0
		-	V	a
		9
		3		S
		-
		7
		6
		3
		0		Text
			S
			P ple
			AM	Sam
				Z
	L		FREQ	0H
	MODE	SN		50
				/6

s u t a r a p p A o e id V / io d u A

A

S

U

IN

E

AD

M

A C , S I V O L C , O C L PE Y B G F M

K K 1 9

PRODUCT LABEL

Figure 7. Product Serial Number Label

DESKTOP INSTALLATION

WARNING: Do not place the NVR5100 on its side; in this position, the unit is likely to fall over and may cause equipment damage or personal injury.

To install the NVR5100 on a desktop:

1.Make sure the rubber feet are installed on the unit to prevent surface damage. If not, secure each rubber foot to the indicated locations on the bottom panel of the unit. Use the five 8-32 x 0.375-inch Phillips pan head screws (supplied).

2.Remove the two chassis brackets from the sides of the unit, if they are attached. Remove the 10-32 x 0.25-inch Phillips pan head screws (six per bracket). Save the brackets and screws for possible future use.

3.Position the unit to allow for cable and power cord clearance at the rear of the unit.

REMOVE BRACKETS

AND SCREWS

Figure 8. Installing Rubber Feet and Removing Brackets

14 C1621M-E (9/08)