Pelco C3662M DS XPRESS WITH XMUX2 INSTALLATION, Audio Out Ground Ground Ground Ground

Figure 3. Rear Panel of DS Enterprise SAVR

AUDIO IN 1

AUDIO IN 2

AUDIO IN 3

AUDIO IN 4

AUDIO OUT 1

AUDIO OUT 2

AUDIO OUT 3

AUDIO OUT 4

GROUND 1

GROUND 2

GROUND 3

GROUND 4

Figure 4. DS Enterprise SAVR Audio Connector

DS XPRESS (WITH XMUX2) INSTALLATION

To install DS XPress with XMUX2, refer to Figure 5 on page 13, and then complete the following steps:

1.Plug the power cord into the power connector ì.

2.Item î is the COM1 connector, which is used to connect RS-232-based PTZ cameras. Refer to PTZ Installation on page 29 for installation details.

3.Plug the monitor into the monitor connector ï and its power cord into an electrical outlet.

4.Connect the network port ñ to the network switch using Cat5 cable.

5.Plug the USB mouse into a USB connector ó.

6.Plug the USB keyboard into a USB connector r.

7.Plug a USB printer into a USB connector s.

8.Plug PC speakers into the line out connector t.

9.Item u is the FlashGuard cardlet relay output (bottom two pins), which can be used to trigger an alarm when a critical error occurs. Connect the alarm to the bottom two pins of the 6-pin terminal block. Refer to the FlashGuard and the WatchDog Service on page 40 for more details about the relay output. The top four pins in u are the COM5 connector, which is used to wire RS-422–based PTZ cameras.

12 C3662M (6/08)