Pelco C3662M installation manual Ds Xpress With Internal Camera Inputs Installation, Output

DS XPRESS (WITH INTERNAL CAMERA INPUTS) INSTALLATION

To install DS XPress with internal camera inputs, refer to Figure 7 on page 15, and then complete the following steps:

1.Plug the power cord into the power connector ì.

2.Item î=is the COM1 connector, which is used to connect RS-232-based PTZ cameras. Refer to PTZ Installation on page 29 for installation details.

3.Plug the monitor into the monitor connector ï and its power cord into an electrical outlet.

4.Connect the network port ñ to the network switch using Cat5 cable.

5.Plug the USB mouse into a USB connector ó.

6.Plug the USB keyboard into a USB connector r.

7.Plug a USB printer into a USB connector s.

8.Item t shows the connector for the 16 digital inputs and alarm output. Wire your alarm triggers into the input trigger block and connect the signal ground to a GND pin. Wire an alarm device to AO+ and AO–.

9.Plug PC speakers into the line out connector u.

10.Item ~í is the FlashGuard cardlet relay output (bottom two pins), which can be used to trigger an alarm when a critical error occurs. Connect the alarm to the bottom two pins of the 6-pin terminal block. Refer to the FlashGuard and the WatchDog Service on page 40 for more details about the relay output. The top four pins in u are the COM5 connector, which is used to wire RS-422–based PTZ cameras.

11.Item ~â is the audio connector bracket. From top to bottom are audio inputs 1–4, audio outputs 1–4, and four grounds.

12.Item ~ä is an optional SCSI card, which is used to connect to external storage units.

13.Connect cameras to the camera inputs ~ã. Inputs 17–32 are available only on 32-input systems.

14.The four connectors indicated by ~å are multicamera video outputs. The following table shows how the outputs are used:

Table A. DS XPress Multicamera Outputs

DS XPress system	Output 1	Output 2	Output 3	Output 4
16 inputs, 1 board	1–16	Unused	Unused	Unused
16 inputs, 2 boards	1–8	9–16	Unused	Unused
16 inputs, 4 boards	1–4	5–8	9–12	13–16
32 inputs, 2 boards	1–16	17–32	Unused	Unused
32 inputs, 4 boards	1–8	9–16	17–24	25–32

15.Plug the power cord into an electrical outlet and turn on the power switch ~ç.

16.To turn on the system, use the power switch on the front panel of the unit.

14 C3662M (6/08)