XMUX2 INSTALLATION
To install an XMUX2 unit, refer to Figure 29, Figure 30, and Figure 31, and then complete the following steps:
1.Connect your cameras to the video input connectors ì. There are 16 inputs on an
2.
3.Connect the Aux connectors ï to monitors, VCRs, or other analog devices, if desired. The multicamera output (Aux1) displays up to 16 cameras, as configured in DSAdmin. The Aux
4.Wire any alarm triggers into the input portion of the trigger block ñ. Connect the signal ground to the GND pin. Wire an alarm signal to the output portion of the trigger block (NO, C, and NC) so you can see when a designated alarm is set or tripped.
5.Connect the
6.Connect the
Repeat these steps for each XMUX2 unit and XPress board.
NOTE: XMUX2 units are powered by the DS component they are connected to; there is no power switch on an XMUX2.
Figure 29. Rear Panel of
Figure 30. Rear Panel of
Figure 31. XMUX Cable
28 | C3662M (6/08) |