Pelco c649m operation manual Rear Terminal Menu

<REAR TERMINAL>

CALL OUT	WRNG•TAPE END
CLOCK OUT	REC- 1
MODE OUT	REC
REC IN	SERIES

Figure 13. Rear Terminal Menu

REC MODE	Sets the recording mode.
	•	NORMAL<SP> – Choose SP (standard play) when higher
		picture quality is desired. With this setting, the recording
		time mode is switched in the following order: 2H, L24H,
		48H, 72H, 96H, 120H, 168H, 0H, 2H.
	•	H•D<EP> – Select the EP (extended play) setting to make
		high density recording. This provides three times more
		fields than normal density (SP). It reduces the time interval
		between pictures, providing more pictures for smoother
		time-lapse recording. With this setting, the recording time
		mode is switched in the following order: 6H, L18H, 48H,
		72H, 96H, 120H, 168H, 0H, 6H.
ONESHOT•	Sets the number of fields to record in the one-shot mode. When
FIELD	you turn the JOG dial to the right, the display switches in the
	following order: 1, 2, 3, 4, 5, 10, 20, 30, 1. The default is 1.
ONESHOT•	Sets the interval time in one-shot mode. When you turn the
INTERVAL	JOG dial to the right, the display switches in the following order:
	SHOT, 10S (second), 15S, 30S, 45S, 1M, 2M, 3M, SHOT. The
	default is SHOT.

6.8 REAR TERMINAL MENU

CALL OUT	Sets the call signal output at the end of the tape. Turns on or off
	the signal that comes from the CALL terminal when the end of
	the tape is reached during recording. If any problems occur
	during recording, a call signal is output from the CALL terminal
	on the rear panel regardless of the CALL OUT setting. The
	default is WRNG•TAPE END.
	• WRNG•TAPE END – A signal is output at the end of the
	tape or when a malfunction occurs.
	• WRNG•REMAIN – The signal is output when a malfunc-
	tion occurs in the VCR or when the tape has about three
	minutes left in 2H mode.
	• WRNG – When a malfunction occurs in the VCR during
	recording, a call signal is output.
	CALL OUT is used in conjunction with TAPE END (First Time
	Set Up menu) to determine when the call signal is output, as
	shown in Table B.

Table B. Call Out/Tape End

		CALL OUT
TAPE END		setting	WRNG•TAPE END	WRNG•REMAIN	WRNG
setting
	STOP		Outputs a call signal at the	Outputs a call signal 3 minutes	When a malfunction occurs in
			end of the tape.	before the end of the tape	the VCR during recording, a call
					signal is output
	REWIND		Outputs a call signal at the	(same as above)	(same as above)
			end of the tape for 2 seconds.
	REPEAT		(same as above)	(same as above)	(same as above)
	When there are no		(same as above)	(same as above)	(same as above)
ALARM	alarm recordings
	during recording.
•PROT
	When there are alarm		Outputs a call signal at the	(same as above)	(same as above)
	recordings during		end of the tape.
	recording.

24 Pelco Manual C649M (7/99)