Pelco c649m operation manual Maintenance Menu, Clock OUT, Rec, Mode OUT, Series

CLOCK OUT	Sets the number of frames or fields to record (depending on the
	recording mode) at the CLOCK OUT terminal. The default is
	REC.
	1.	First, set the recording mode for the CLOCK OUT pulse
		output in the Rear Terminal menu.
		• REC – When recording in any mode.
		• T/L-REC – When recording in time-lapse mode
		(L18H, L24H, 48H, 72H, 96H, 120H, 168H, or 0H).
	2.	Second, select the frequency interval by turning the
		SHUTTLE ring. When you turn the JOG dial, the display
		switches in the following order: 1, 2, 3, 4, 5, 10, 15, 20,
		25, 30, 50, 60, F (field), 1. The numbers from 1 to 60
		indicate the number of frames in 2H or 6H recording mode
		or the number of fields in time-lapse recording mode. One
		frame consists of two fields. One field is selected when it
		is set to “F” (field).
MODE OUT	Sets the state in which the signal output at the MODE OUT
	terminal is switched to active. When you turn the JOG dial, the
	display switches in the following order: REC (recording), PLAY
	(playback), POWER (power on), TAPE IN (tape inserted),
	TAPE REMAIN (three minutes in 2H mode before the tape
	ends), CLOCK ADJ (output the signal for one second when the
	clock indicates 00[min]:00[sec]), REC. The default is REC.
REC IN	Sets the REC IN terminal’s operation mode. The default is
	SERIES.

•SERIES – Recording starts when the REC IN terminal is short-circuited to ground or a low-level voltage (0 to +1.6V) is applied.

•REC-START/STOP – Recording starts when the REC IN terminal is short-circuited to ground or a low-level voltage (0 to +1.6V) is applied. Recording stops if this connection is removed.

•SYNC REC – The video signals from 3 or 13 cameras can be recorded separately by connecting a switcher. (Synchronous recording is available when recording in L18H or L24H mode.) Synchronous recording is explained (and the procedure listed) in Section 8.1.7.

6.9MAINTENANCE MENU

<MAINTENANCE>

POWER LOSS LIST

ALARM LIST

ALL MENU INITIALIZE

POWER LOSS LIST CLEAR

ALARM LIST CLEAR

<REPEAT REC TIMES>	0
<ELAPSED TIME>	0H

Figure 14. Maintenance Menu

POWER LOSS To display the power loss list, turn the JOG dial to select

LISTPOWER LOSS LIST. Turn the SHUTTLE ring to the right to display the list. Power failure start times are stored in memory, so you can confirm when they occurred. Up to three power failure start times will be displayed. If there were more than three, the first and last two power failure start times will be displayed.

ALARM LIST To display the alarm list, turn the JOG dial to select ALARM LIST. Turn the SHUTTLE ring to the right to display the list. Alarm record start times are stored in memory, so you can confirm when they occurred. Up to three alarm record start times will be displayed. If there were more than three, the first and last two alarm record start times will be displayed.

Pelco Manual C649M (7/99) 25