Patterns
SPECTRA III
LANGUAGEENGLISH
<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT
DOME SETTINGS
A pattern is a memorized, repeating, series of pan, tilt, zoom and preset functions that can be recalled with a command from a controller or automatically by a programmed function (alarm, park or
The Spectra III SE can handle up to four
To program a pattern:
1.Use the joystick to position the cursor beside PATTERN NUMBER. Press Iris Open. The cursor moves to the right.
2.Move the joystick up or down to view selections. Press Iris Open to enter selection.
<CAMERA>
<MOTION> <POWER UP> <LINE SYNC> <PRESETS> <PATTERNS> <ZONES>
<WINDOW BLANKING> <ALARMS>
<AUX>
<TITLE TEXT> <ALERT>* <CLEAR> <PASSWORD>
BACK
EXIT
PATTERNS
PATTERN NUMBER | 1 |
<PROGRAM PATTERN> |
|
<CLEAR PATTERN> |
|
BACK |
|
EXIT |
|
REFERENCE INFORMATION |
|
PATTERN USAGE | 0% |
REMAINING | 100% |
*This setting only applies to Pressurized Spectra III SE dome systems with software version 1.25 or higher.
3.Use the joystick to position the cursor beside PROGRAM PATTERN.
4.Press Iris Open. The Patterns programming window appears on the monitor.
5.Follow the directions displayed on the monitor.
After a pattern is programmed, the remaining storage percentage is displayed on the screen. This is the amount of memory available to program the remaining patterns.
To clear a pattern:
1.Use the joystick to position the cursor beside CLEAR PATTERN.
2.Press Iris Open.
3.Follow the directions displayed on the monitor.
NOTE: When programming one or more presets within a pattern, use the normal controller commands to Call a Preset. Not all controllers can start all four patterns. However, any of the four patterns can be automatically started with park,
36 |
