SPECTRA III
LANGUAGEENGLISH
<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT
DOME SETTINGS
<CAMERA>
<MOTION> <POWER UP> <LINE SYNC> <PRESETS> <PATTERNS> <ZONES>
<WINDOW BLANKING> <ALARMS>
<AUX>
<TITLE TEXT> <ALERT>* <CLEAR> <PASSWORD>
BACK
EXIT
WINDOW BLANKING
STYLE | GRAY |
BLANK ALL ABOVE | OFF |
BLANK ALL BELOW | OFF |
<SET WINDOWS> |
|
BACK |
|
EXIT |
|
SET WINDOWS |
|
WINDOW NUMBER | 1 |
<EDIT WINDOW LOCATION> |
|
<EDIT WINDOW ZOOM> |
|
ENABLE WINDOW | NO |
REVERSE |
|
CLEAR WINDOW |
|
BACK |
|
EXIT |
|
*This setting only applies to Pressurized Spectra III SE dome systems with software version 1.25 or higher.
6.The blanked area can be programmed to turn on or off at a specified zoom point. To set the zoom point:
a.Use the joystick to position the cursor beside EDIT WINDOW ZOOM, and then press Iris Open.
b.Zoom in to the point where you want window blanking to turn on. Press Iris Open to set the zoom point.
NOTE: Since the area is already blanked out, it may be difficult to determine when you want window blanking to turn on. Reverse the window before setting the zoom point. When finished reverse the window again to blank out the area.
Window Blanking Disabled | Window Blanking Enabled |
NOTE: Increase the size of the window if any part of the blanked area is revealed during pan, tilt, and zoom operations.
Quick Programming Guide
(See page 11)
39 |
