Aux
SPECTRA III
LANGUAGEENGLISH
<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS>
ACK ALERT*
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT
DOME SETTINGS
<CAMERA>
<MOTION> <POWER UP> <LINE SYNC> <PRESETS> <PATTERNS> <ZONES>
<WINDOW BLANKING> <ALARMS>
<AUX>
<TITLE TEXT> <ALERT>* <CLEAR> <PASSWORD>
BACK
EXIT
AUX
AUX 1 MODE | TOGGLE |
DWELL TIME (SECS) | 1 |
AUX 2 MODE | TOGGLE |
DWELL TIME (SECS) | 1 |
BACK |
|
EXIT |
|
An auxiliary output is a programmable signal from the dome back box that can trigger another device to operate. An auxiliary output is programmable to trigger from an alarm or from a controller.
An AUX 1 command from the controller will activate the relay in the dome and operate the device that is connected to the relay. The output of AUX 1 can be connected to the alarm input of a system switch to activate automatic monitor switching and recording.
An AUX 2 command from the controller will place a ground at the output of AUX 2 to operate the device that is connected to it.
The following are the available AUX MODE settings:
TOGGLE (default) | Changes the state of the auxiliary output every time an AUX command |
| is received from the controller. |
LATCHING | Must receive an AUX ON/AUX OFF command from the controller to turn |
| the auxiliary output on/off. |
MOMENTARY | An AUX ON command from the controller turns the auxiliary output on |
| for the programmed DWELL TIME. The auxiliary output will auto- |
| matically turn off when the dwell time is finished. |
*This setting only applies to Pressurized Spectra III SE dome systems with software version 1.25 or higher.
44 |
