Pelco DD53CBW-X manual Zones, Quick Programming Guide

Zones

SPECTRA III

LANGUAGEENGLISH

<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS>

ACK ALERT*

RESET CAMERA

CYCLE CAMERA POWER

REBOOT SYSTEM

EXIT

DOME SETTINGS

<CAMERA>

<MOTION> <POWER UP> <LINE SYNC> <PRESETS> <PATTERNS> <ZONES>

<WINDOW BLANKING> <ALARMS>

<AUX>

<TITLE TEXT> <ALERT>* <CLEAR> <PASSWORD>

BACK

EXIT

ZONES

ZONE NUMBER	1
* * * ZONE NOT DEFINED * * *
<EDIT ZONE LABEL>
<EDIT ZONE>
ZONE ENABLED	NO
ZONE BLANKING	OFF
<CLEAR ZONE>

A zone is a pan area, defined by a left and right limit, on the 360-degree pan plane. The Spectra dome system is capable of eight zones, each with a 20-character label.

To program a zone:

1.Use the joystick to position the cursor beside ZONE NUMBER. Press Iris Open the cursor moves to the right.

2.Move the joystick up or down to view selections. Press Iris Open to enter selection.

3.Use the joystick to position the cursor beside EDIT ZONE.

4.Press Iris Open. The Zone programming window appears on the monitor.

5.Follow the directions displayed on the monitor. After the left and right limit stops are set, the Zones menu reappears with the ZONE ENABLED option set to YES.

To edit a zone label:
1.	Use the joystick to position the cursor beside EDIT ZONE LABEL.
2.	Press Iris Open. The following appears on the monitor:
	LABEL FOR ZONE
	ZONE NUMBER ------	OK
	1234567890
	ABCDEFGHIJ	CANCEL
	KLMNOPQRST
	UVWXYZ.,-/	SPACE
	abcdefghij	BACKSPACE
	klmnopqrst
	uvwxyz#&:*

3.Use the joystick to position the cursor beside a character. Press Iris Open to enter selection. To clear a character, position the cursor beside BACKSPACE, and then press Iris Open.

4.When the label is completed, move the cursor the OK. Press Iris Open to return to the Zones menu.

To disable a zone (a zone is enabled automatically when it is programmed) or to blank a zone:

BACK

EXIT

*This setting only applies to Pressurized Spectra III SE dome systems with software version 1.25 or higher.

1.Move the cursor beside ZONE ENABLED or ZONE BLANKING.

2.Press Iris Open. The cursor moves to the right.

3.Move the joystick up or down to view selections. Press Iris Open to enter selection.

To clear a zone:

1.Use the joystick to position the cursor beside CLEAR ZONE.

2.Press Iris Open. Follow the instructions on the screen.

Quick Programming Guide

(See page 11)

C2445M-E (11/05) 37