Pelco IV SE manual Patterns

PATTERNS

PELCO SPECTRA IV SE HORIZON

LANGUAGE

<SYSTEM INFORMATION> <DISPLAY SETUP>

<DOME SETTINGS>

RESET CAMERA

CYCLE CAMERA POWER

REBOOT SYSTEM

EXIT

DOME SETTINGS

<CAMERA>

<MOTION> <POWER UP> <LINE SYNC> <PRESETS>

<PATTERNS>

<ZONES>

<WINDOW BLANKING> <ALARMS>

<AUX>

<TITLE TEXT> <CLEAR> <PASSWORD> <CLOCK> <EVENT>

BACK

EXIT

PATTERNS

PATTERN NUMBER <PROGRAM PATTERN> <CLEAR PATTERN> <EDIT SCHEDULE>

BACK

EXIT

REFERENCE INFORMATION

PATTERN USAGE

REMAINING

A pattern is a memorized, repeating series of pan, tilt, zoom, and preset functions that can be recalled with a command from a controller or automatically by a programmed function (alarm, park, event, or power-up).

The Spectra IV SE Horizon can handle up to eight patterns. Pattern length is based upon memory usage rather than a fixed amount of time. The complexity of a pattern will determine the amount of storage available to program other patterns.

NOTE: In most cases, the memory available will allow for ample time to schedule typical patterns. If the scheduled patterns are unusually lengthy or complex, there is a possibility that there may not be enough remaining memory to program all eight patterns.

To program a pattern:

1.Use the joystick to position the cursor beside PATTERN NUMBER. Press Iris Open. The cursor moves to the right.

2.Move the joystick up or down to view selections. Press Iris Open to enter selection.

3.Use the joystick to position the cursor beside PROGRAM PATTERN.

4.Press Iris Open. The Patterns programming window appears on the monitor.

5.Follow the directions displayed on the monitor.

After a pattern is programmed, the remaining storage percentage is displayed on the screen. This is the amount of memory available to program the remaining patterns.

To clear a pattern:

1.Use the joystick to position the cursor beside CLEAR PATTERN.

2.Press Iris Open.

3.Follow the directions displayed on the monitor.

To edit the pattern schedule:

The Edit Schedule menu is a duplicate of the Edit Event menu in the Event section with the following exceptions. In the Edit Schedule menu, the event type cannot be changed. Also, the Holiday feature cannot be accessed from the Edit Schedule menu.

For instructions on changing the features in the Edit Schedule menu, refer to the Edit Event section on page 69.

NOTE: When programming one or more presets within a pattern, use the normal controller commands to Call a Preset. Not all controllers can start all patterns. However, any of the patterns can be automatically started with park, power-up, event, and alarm functions.

52 C3434M-A (9/07)