Installation
NOTES:
•Please refer to the Important Note shipped with the dome drive before installing the back box, dome drive, or lower dome. The Important Note contains vital information about managing the bubble seam.
•This manual contains installation instructions only for the Spectra IV SE Horizon dome drive. For complete installation instructions for a Spectra IV SE Horizon dome system, refer to the installation manual shipped with the back box.
SWITCH SETTINGS
Before installing the dome drive, configure the receiver address, termination, and baud setting. The DIP switches used to configure these settings are located on the base of the dome drive.
Figure 1 shows the default settings for the DIP switches. Switch
Refer to the following sections to set the address, termination, and baud settings for the dome drive.
O N |
|
|
|
|
|
|
|
| |
SW2 |
|
|
|
|
|
|
|
|
|
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 |
SW1
O N |
|
|
|
|
|
| |
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 |
Figure 1. Default Switch Settings
SW1: RECEIVER ADDRESS
Set the SW1 switches for the address of the dome drive. The following information is required to set the dome drive address:
•
•
7 |