Display Setup
PELCO SPECTRA IV SE HORIZON
LANGUAGE
<SYSTEM INFORMATION> <DISPLAY SETUP> <DOME SETTINGS>
RESET CAMERA
CYCLE CAMERA POWER
REBOOT SYSTEM
EXIT
DISPLAY SETUP
PRESET LABEL
ZONE LABEL ZOOM AZIMUTH/ELEVATION DIRECTION ALARM MESSAGE DATE/TIME <LABEL POSITIONS>
RESTORE FACTORY DEFAULTS
BACK
EXIT
Display setup allows you to program how labels are displayed on the monitor. The following labels are available:
PRESET LABEL | Identifies preset. |
ZONE LABEL | Identifies zone. |
ZOOM | Identifies the amount of magnification. |
AZIMUTH1/ELEVATION2 | Amount of pan from zero degrees vertical and the amount of tilt |
| from zero degrees horizontal. |
DIRECTION | Displays compass direction. |
ALARM MESSAGE | Displays activated alarm. |
DATE/TIME | Displays current date and time. |
EVENT LABEL | Displays activated event. |
A preset label is displayed when a preset is called. A zone label is displayed when the system moves into a zone. The zoom ratio label is displayed when zoom is activated. Azimuth/elevation and direction labels are displayed when pan/tilt is activated. An alarm message appears on the monitor when an alarm occurs. An event label appears on the monitor when an event occurs.
The following settings are available for each label except date and time:
OFF | Label is not displayed when activated. |
CONSTANT | The label is continually displayed when activated. |
2 SECONDS | The label is displayed for 2 seconds after activation. |
5 SECONDS | The label is displayed for 5 seconds after activation. |
10 SECONDS | The label is displayed for 10 seconds after activation. |
The settings for date and time are ON or OFF.
1Azimuth is the pan angle from zero to 359 degrees.
2Elevation is the tilt position from 18 to
28 |
