2

Caution

•Do not short the batteries or dispose of the batteries in fire. Do not disassemble the batteries. The batteries could explode or catch fire.

•Of the batteries that can be used in this camera (AA Ni-MH batteries, AA lithium batteries and AA alkaline batteries), only the Ni-MH batteries can be recharged. Recharging other batteries can cause a fire or explosion.

•Remove the batteries from the camera immediately if they become hot or begin to smoke. Be careful not to burn yourself during removal.

•Some portions of the camera heat up during use. There is the risk of low temperature burns when holding such portions for long periods.

•Do not place your finger over or cover the flash with clothing when discharging the flash. Fingers or clothing may be burned.

•To reduce the risk of hazards, use only CSA/UL Certified power supply cord set, cord is Type SPT-2 or heavier, minimum NO.18 AWG copper, one end with a molded-on male attachment plug cap (with a specified NEMA configuration), and the other is provided with a molded-on female connector body (with a specified IEC nonindustrial type configuration) or the equivalent.

PRECAUTIONS FOR BATTERY USAGE

•Only use the specified batteries with this camera. Use of other batteries can cause a fire or explosion.

•Replace all the batteries at the same time. Do not mix battery brands, type or an old battery with a new one. It may cause explosion or a fire.

•The batteries should be inserted correctly with regard to polarity (+ and –) marked on the batteries and the camera. Not inserting batteries correctly may cause explosion or a fire.

•Do not disassemble the batteries. Of the batteries that can be used in this camera, only the Ni-MH batteries can be recharged. Disassembling the batteries or attempting to charge non-rechargeable batteries could result in explosion or leakage.

Care to be Taken During Handling

•When traveling, take the Worldwide Service Network that is included in the package. This will be useful if you experience problems abroad.