Basic Television Connection | Philips 26HW9100D, 30HW9100D guide

L05 User’s Manual

091105.1833

Basic Television Connection

Antenna Connection

• Connect the antenna or RF cable signal to the 75-ohm RF ‘F’ connector socket located on the TV’s rear jack panel.

Mains Connection

• Verify that the mains voltage and frequency are correct. Please refer to the product labeling and documentation. Note: The power button on the front panel does not disconnect the television from the AC mains; it toggles the TV’s power mode between on and standby. To completely remove AC mains power, you must unplug the AC mains plug.

Switching on the Set

• Press the power button on the TV’s front panel or on the remote control to switch on the set.

Note 1: If the TV is in commercial mode, it might not respond to the front panel or the remote control, depending upon the TV’s mode and setup configuration. Please refer to the section TV Installation and TV Setup Menu in this documentation for more information.

Note 2: See Mains Connection, above.

4

Image 4

Philips 26HW9100D, 30HW9100D user manual Basic Television Connection

Contents

26HW9100D/30HW9100D User’s Manual Safety Information Before Calling Service Symptom Possible Corrective Action Basic Television Connection Use And Care of Remote Control Rear Jack Panel Connections Remote Controls Guest Remote Control Keys DVD Stop Consumer vs. Commercial Mode Accessing TV Setup MenusPage TV Setup Main Menu TV Setup Menu and Sub-Menus Installing AV Inputs ∙ Label∙ Video Blank ∙ Audio Mute Factory CH Reset Cursor Right will reset the channels programmed in memory∙ Major Channel ∙ Minor Channel USE Channel Table NO/YES Digital OSDNO/YESEnter Digital Menu Cursor Right will bring up the Consumer Digital Menu below Default Format BrightnessColor Contrast Using the different formats Noise Reductionno / YES Sound Mode Mono / Stereo Volume BARAvloff / on Balance MAX Volume Switch on Volumestandard / 0Power Onstandard / Forced /RESTORED Channel Displaynone / Number / Label / ALL ESP AUDIO/VIDEO Muteoff / Black / BlueAUDIO/VIDEO OUT Mute Monitor OUT Rfno / YES Channel Guide No / YES / Power on ∙ DISPLAYNO/YES∙ Line 1/LINE ∙ Clear CH A/V Switchno / YES Reminderno / YESDigit Entryno / YES Most recently selected channel / input Source Menu Itemno / YES Save Ccno / YESHdmi Audio Selectionhdmi / AV1 / AV2 / AV Chip Setup SleeptimerChip Menu Itemno / YES Save V-CHIPNO / YES Sleeptimer Countdown In Progress example Security Standard / High 26HW9100D Dimensions 30HW9100D Dimensions