Philips 28PW6516/01 manual Adjusting the sound level

Adjusting the sound

&Press H, select the SOUND option (J) and press L.The SOUND menu appears :

SOUND

• PICTURE	• LEVEL	120 HZ
• SOUND
• FEATURES	• EQUALIZER	500 HZ
• INSTALL	• SURROUND MODE	1500 HZ
	• DELTA VOLUME	5 KHZ
	• STORE	10 KHZ

•AVL

•CORDLESS

•DELAY

éUse IJkeys to select a setting and keys KLto adjust.

Note: to access the AVL, CORDLESS and DELAY

settings (hidden at the bottom of the screen) hold down Jkey.The CORDLESS and DELAY settings are only availables if surround loudspeakers are connected to the TV set.The DELAY setting only appears in DOLBY PRO LOGIC and HALL SURROUND modes.

“Once the necessary adjustments have been made, select the option STORE and press L to store them.

‘To exit from the menus, press R.

Description of the settings:

•LEVEL: to balance the sound between the different speakers (see below).

•EQUALIZER: to adjust the sound tone (from

bass: 120 Hz to treble: 10 kHz).

•SURROUND MODE: to select the different surround modes (see next page).

•DELTA VOLUME (volume difference): allows you to compensate for the volume differences between the different programmes or the EXT sockets.This setting is available for programmes 1 - 40 and the EXT sockets.

•STORE: stores the sound settings.

•AVL (Automatic Volume Leveller): automatic volume control used to avoid sudden increases in volume, particularly when changing programmes or during advertisements.

•CORDLESS: to adjust the different parameters of the cordless surround speakers (see p. 17).

•DELAY: to adjust the delay of surround effect on the rear loudspedakers (31 is the default value).

Adjusting the sound level

This menu allows you to balance the sound between the different speakers.

&Press H, select SOUND (J) and press L. The SOUND menu appears :

SOUND

• PICTURE	• LEVEL	TEST
• SOUND
	• EQUALIZER
• FEATURES		BALANCE
• INSTALL	• SURROUND MODE	CENTRE
	• DELTA VOLUME	REAR

•STORE

•AVL

•CORDLESS DELAY

éSelect TEST and press Lto set it to ON. A continuous sound is emitted in turn from each channel : left, right, centre and rear

(depending on the selected surround mode). Remark : the rear channel only appears if surround speakers are connected to the TV set.To change the surround mode, press the )key.

“Select BALANCE, CENTRE or REAR and use the KLkeys to adjust the level of each channel independently.The sequence stops

while the level is being changed and then automatically starts up again.

‘To stop the test, press H.

Levels may also be adjusted without using the test signal.

( To exit from the menus, press R.

8