Philips DV900VHS owner manual Real-Time Counter Memory

42 Real-Time Counter Memory

VCR

Follow the steps below to reset the real-time counter to zero at a tape location you want to refer to later.

●Before you begin, place the DVD/VCR in VCR mode.

Press the DVD/VCR OUTPUT button so that the green VCR light appears on the front of the DVD/VCR.

1

Press the VCR button, then play, fast forward, or rewind a tape to the location that you would like to refer to later. Press the STOP button to stop the tape.

2

Press the DISPLAY/STATUS/EXIT button to see the sta- tus display.

STOP	1:08PM
TV STEREO	CH10

SLP 1 : 23 : 45 HIFI

3

While the status display is on the screen, press the CLEAR button to reset the real-time counter to zero.

STOP	1:08 PM
TV STEREO	CH10

1

2

POWER		TIMER SET
VCR/TV	DVD/VCR		MEMORY
	OUTPUT
DVD			VCR
	PLAY
REW			F.FWD
	STOP
CHANNEL			RD
			RECO
	SKIP
			PAUSE
1	2	3
4	5	6
7	8	9	SLOW
			A B
SPEED		+10
	0
SEARCH MODE	DISPLAY	CLEAR
TIME SEARCH	STATUS/EXIT		REPEAT
		MENU	TITLE
		ENTER	RETURN

SETUP MODE AUDIO SUB TITLE ANGLE

4

5

3

SLP 0 : 00 : 00 HIFI

4

While the real-time counter is on the screen, press the MEMORY button so that M appears beside the counter.

STOP	1:08 PM
TV STEREO	CH10
SLP M 0 : 00 : 00	HIFI

5

To go to a tape location where the real-time counter was reset to zero, press the REW(ind) button or the F.FWD button when playback is stopped.

When the tape reaches the point at which the counter was set to zero, the tape will stop.

Press the PLAY button to watch the tape.

Helpful Hints

•The MEMORY button does not function if REPEAT PLAY is set to ON. Details are on page 41.

•To erase a real-time counter memo- ry, press the MEMORY button until the M disappears from the screen.

•You may only set the real-time counter to zero at one location at a time. If you set the real-time counter to zero at a second location, the previous real-time counter to zero setting will be erased.