Philips HB933, HB945 manual Storage, Replacement, Ordering scent granules, Environment

English

3Clean the protective goggles with a moist cloth.

Storage

Let the appliance cool down for 15 minutes before you put it in transport position and store it.

1Store the protective goggles in the storage compartment between the two lamps. (Fig. 38)

2Put the remote control and the cord in the pouch on the back of the control panel (HB947 only). (Fig. 39)

3Make sure the cord does not get stuck between parts of the appliance when you put the appliance in transport position.

4Turn the appliance away from the bed or sofa and make sure there is enough space around the appliance to collapse it.

5Press the two release buttons in the recesses of the control panel and slide the control panel down the stand as far as it goes. (Fig. 40)

6Turn the lamp unit in the direction of the arrow. (Fig. 41)

You hear a click when the lamp unit locks in vertical position.

7Pull the stand slightly backwards and then press the dual push button. Lower the stand slowly until the lamp unit rests on the floor between the legs. (Fig. 42)

8Wind the cord and fasten it with the Velcro cord wrap strip. (Fig. 43)

,You can store the appliance in a wardrobe or under a bed.

Replacement

Tanning lamps

Have the Philips tanning lamps (Cleo HPA Synergy) replaced by a service centre authorised by Philips. Only they have the knowledge and skills required for this job and the original spare parts for the appliance.

The light that the tanning lamps emit becomes less bright in time (i.e. after a few years in case of normal use). When this happens, you notice a decrease in the tanning capacity of the appliance.

-After 750 operating hours the tanning capacity of the lamps has decreased so much that replacement of the tanning lamps is advisable.

-HB947/HB945: the appliance has a counter that records the operating hours of the tanning lamps. After 750 operating hours, an L appears on the left-hand side of the display to indicate that replacement of the tanning lamps is advisable (Fig. 44).

Note:Of course, you can choose to postpone replacement for a while by setting a longer tanning time.

Viewing the operating hours of the tanning lamps

1Set the time to 00 and press the repeat button ( ä) at least 2 seconds to make the operating hours appear on the display.

The maximum number of hours that can be displayed is 999.When this value has been reached, the counter starts to count up from 000 again.

Note:The operating hours disappear from the display as soon as you release the repeat button ( ä).

HB947/HB945: removing the L from display

To remove the L from the display:

1Make sure time indicated on the display is 00.

2Press and hold down the START/STOP button.

3Press and release the repeat button ( ä).

4Press and release the pause button ( ã).

5Press and release the repeat button ( ä).

6Press and release the repeat button ( ä).

7Release the START/STOP button (Fig. 45). The L disappears from the display.

Other parts

Have the Philips infrared lamps (1100W) and the UV filters replaced by a service centre authorised by Philips. Only they have the knowledge and skills required for this job and the original spare parts for the appliance.

-Have the infrared lamps replaced when they stop functioning.

-The UV filters protect against exposure to undesired UV light. It is therefore important to have a damaged or broken filter replaced right away.

-If the mains cord is damaged, it must be replaced by Philips, a service centre authorised by Philips or similarly qualified persons in order to avoid a hazard.

Ordering scent granules

You can obtain scent refill packages with 3 sachets of scent granules under type number HB080 through www.philips.com/shop or from your

Innergize dealer.

Environment

,The lamps of the appliance contain substances that can be harmful to the environment.When you discard the lamps, make sure they are not thrown away with the normal household waste, but handed in at an official collection point.

,Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment (Fig. 46).