6. Set Up
4.To switch off the mains supply completely, pull the mains plug out of the wall socket.
Note: Before disconnecting the power cord, make sure that the
cooling fan has stopped (about 3 minutes after the projector has been switched to Standby).
Adjusting the focus of the image
•Use the Focus ring to adjust the focus of the image.
Focus ring
Adjusting height and level of the projector
•Use the Height/Level Adjuster to adjust the vertical angle of the projector as specified under ‘Positioning the projector and screen’.
Projection angle
•Press the adjuster button on the top cover of the projector.
•Lift the projector to allow the adjuster leg to drop into position.
•Release the button. The extended adjuster legs will be locked.
Skew correction
•Turn the rear adjuster either
•Use the Focus ring to readjust the focus of the image.
Vertical keystone correction
If projector and screen are not properly placed, the picture will be distorted, producing a
keystone image. Vertical keystone correction allows you to correct picture distortion of the vertical keystone type by internal scaling. By pressing the
fine adjust the projected image.
Moving the projector
1.Press the Standby/On button to switch off the projector. The power will turn off and the Standby/On indicator will blink orange for 1 minute before the standby status will be activated. (The exhaust fan will continue to run for a while for cooling purposes)
2.Wait until the cooling fan has stopped (about 3 minutes after the projector has been switched off) and disconnect the power cord and all other cables.
3.Slide the lens cap back in place to prevent dust, dirt or other contamination from harming or damaging the front of the projector lens when moving the projector.
Note: Never place the projector on the back where the connections are located.
9
