Panasonic PT-AE300U, PT-AE200U manual Using the remote control unit, Connector panel, Operating range

Models: PT-AE300U PT-AE200U PT-AE300U

1 34
Download 34 pages 48.9 Kb
Page 9
Image 9

<Connector panel>

<PT-AE300U>

# %

&

'

(

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

$

<PT-AE200U>

# $ %

'

(

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Using the remote control unit

Operating range

Preparation

#Open the cover.

 

$Insert the batteries so that the polarities are correct, and then close the cover.

+

〇-〇-

+

AAAbatteries (two)

NOTE:

#AUDIO L-R input jacks (page 18)

$VIDEO input jack (page 18)

This jack is used to input video signals from a video equipment such as a video deck.

%S2 VIDEO input connector (page 18 and 30)

This connector is used to input signals from an S-VIDEO- compatible equipment such as a video deck. The connector is compatible with S2 and S1 signals, and projector aspect is automatically adjusted according to the type of signal received.

&DVI-D IN connector (page 20)

This connector is used to input DVI-D signals.

'RGB input connector (page 20)

This connector is used to input RGB signals from a PC.

(YPBPR(CBCR) input jacks (page 19)

These jacks are used to input YPBPR signals from compatible equipment such as DVD players.

BDo not drop the remote control unit.

BKeep the remote control unit away from liquids.

BRemove the batteries if not using the remote control unit for long periods.

BDo not use rechargeable batteries.

Operating range

NOTE:

If the remote control unit is held so

BIf there are any obstacles in between

that it is facing directly in front of the

the remote control unit and the

remote control signal receptors on

receivers, the remote control unit may

the front of the projector, the

not operate correctly.

operating range is within

BIf strong light is allowed to shine onto

approximately 7 m (23´) from the

the remote control signal receiver,

surfaces of the receptors.

correct remote control operation may

Furthermore, the remote control unit

not be possible. Place the projector as

can be operated from an angle of

far away from light sources as possible.

±30° to the left or right and ±15°

BIf facing the remote control unit

above or below the receptors.

toward the screen to operate the

 

projector, the operating range of the

 

remote control unit will be limited by

 

the amount of light reflection loss

 

caused by the characteristics of the

 

screen used.

 

 

16-ENGLISH

ENGLISH-17

Page 9
Image 9
Philips PT-AE300U, PT-AE200U manual Using the remote control unit, Connector panel, Operating range