When adjusting the black or neutral color area of the picture, adjust it using BRIGHT R or BRIGHT B.
WHITE BALANCE R/G/B
(PC only)
This is used to adjust the white areas of the picture if they appear colourised.
Press the I button to make the selected color lighter.
Press the H button to make the selected color stronger.
SIGNAL MODE
(PC/DVI/YPBPR only)
This displays the type of signal which is currently being projected. Refer to the table on page 61 for details on each type of signal.
GAMMA ADJUST
Press the ENTER button to display the GAMMA ADJUST menu.
| GAMMA ADJUST� � | |
WHITE | LEVELS | 0 |
|
|
|
BLACK | LEVELS | 0 |
S E L E C T ENTER | ESC | |
WHITE LEVELS
This is used for correcting the gradation of a bright projected image. To correct a white jump in the picture, press the I buttons. To raise the contrast ratio, press the H buttons.
BLACK LEVELS
This is used for correcting gradation of a dark projected image.
To correct black crushing, press the
Hbuttons. To raise the contrast ratio, press the I buttons.
MEMORY SAVE
Press the ENTER button to display the MEMORY SAVE menu.
MEMORY SAVE� | � | |
MEMORY | 1 |
|
MEMORY | 2 |
|
MEMORY | 3 |
|
S E L E C T | ENTER | ESC |
Up to 3 settings can be saved in the PICTURE menu.
Select the number in which you wish to save the setting by pressing the F or G buttons and then press the ENTER button.
The confirmation screen will then be displayed. Select “OK” by pressing the I or H buttons and press the ENTER button.
MEMORY SAVE
OK CANCEL
MEMORY LOAD
Press the ENTER button to display the MEMORY LOAD menu.
(If any setting is not saved in the MEMORY SAVE menu, the MEMORY LOAD menu will not be displayed.)
MEMORY LOAD� | � | |
MEMORY | 1 |
|
MEMORY | 2 |
|
MEMORY | 3 |
|
S E L E C T | ENTER | ESC |
A setting saved in the MEMORY SAVE menu can be retrieved using MEMORY LOAD. Select the number which you wish to retrieve by pressing the F or G buttons and then press the ENTER button.
NOTE:
BThe MEMORY LOAD menu can also be displayed by pressing the MEMORY USER button.
BThe number with which some settings are saved using MEMORY SAVE will only be displayed in the MEMORY LOAD menu.
Projecting sRGB- compatible pictures
sRGB is an international color reproduction standard
1)established by the International Electrotechnical Commission (IEC). If you would like the colours in
#Press the F or G button to select “PICTURE MODE”, and then use the I or H button to select “NATURAL”.
$Press the NORMAL button on the remote control unit.
%Select the LAMP POWER item in the OPTION menu by pressing the F or G buttons and set to “HIGH” by pressing the I or H buttons.
NOTE:
BsRGB is only enabled when RGB signals are being input .
