NEC NDA-24298 manual Astp Assignment of Signal Translation Pattern

ASTP : Assignment of Signal Translation Pattern

ASTP: Assignment of Signal Translation Pattern

1.General

This command assigns the Incoming/Outgoing Selection Translation Pattern Number (PNI/PNO) for the incoming or outgoing trunk route.

2.Precautions

1.The PNI/PNO is an intermediate parameter to assign an additional number (and skip digits) by the AISP/ AOSP command.

(a)When IC/OG = 1 (Incoming) is entered, the additional number is assigned by the AISP command.

(b)When IC/OG = 2 (Outgoing) is entered, the additional number and skip digits are assigned by the AOSP command.

2.The transmit number translation of the OGC/OGCA method outgoing calls are done by ASTP/AOSP command. Since the additional number and skip digits can be assigned by the AOPR/AADC command for LCR/LCRS method, the ASTP/AOSP command may not be required.

3.The system processes ASTP/AISP commands prior to processing the numbering plan data. If the LCR access code is added to the received numbers by the ASTP/AISP command, the system processes the LCR related commands such as ASPA/AFRS /AOPR.

4.The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX8. Enter the tenant number this command affects. If data for this command is common for all tenants (ASYD command, SYS1, INDEX93, bit4,5=1), assign the TN parameter as data “1” for all tenants.

CHAPTER 4 NDA-24298

Page 278

Issue 1