NEC NDA-24298 manual Chapter

ASYD : Assignment of System Data

	SYSTEM			BIT
SYSTEM		DATA	CORRESPONDING
	DATA
DATA		(DATA)		DATA
	INDEX					SYSTEM DATA CONTENTS
TYPE		00 – FF
(SYS)	(INDEX)	(Hex)	DATA
	0 – 511				BIT
			0/1
			0		b0
			0		b1
			0		b2
			0		b3	Not used
	120		0		b4
			0		b5
			0		b6
						Password Function (Effective		Data for Port 4 of the IOC
					b7	only with MAT)
								Circuit Card
						0/1 = Out/In Service	Note 1
1
			0		b0
			0		b1
			0		b2
			0		b3	Not used
	121		0		b4
			0		b5
			0		b6
						Password Function (Effective		Data for Port 5 for the IOC
			0		b7	only with MAT)
								Circuit Card
						0/1 = Out/In Service	Note 2

Note 1: When setting the data that designates Print/Message Center and MAT, be sure the data is not duplicated in the Port number data assigned by SYS-1, INDEX 288, 290, 292, and 294. When setting the data that designate SMDR, it is necessary to assign the corresponding data to SYS-1, INDEX 288, 290, 292, and 294.

Note 2: Bits 0 ~ 6 are assigned in the AIOC Command. Only bit 7 may be changed using this index.

Note 3: When activating the Password function, assign “b7 = 1” ONLY after a Password Code has been assigned via command APSW.

CHAPTER 4 NDA-24298

Page 104

Issue 1