NEC NDA-24298 manual Anndl Assignment of Necessary Digits Data for LDM, Incoming Number, 899

ANNDL : Assignment of Necessary Digits Data for LDM

ANNDL: Assignment of Necessary Digits Data for LDM

1.General

This command assigns the necessary number of digits for a particular logical trunk route.

2.Precautions

1.This command is needed when the originating call uses both OG mode and signaling as follows:

(a)ASPAL/ASPAN command SRV = OGC/OGCA

(b)ARTD/ARTDN command OSGS = 4/6/7 (Sender Immediate Start/Sender Delay Dial Start/Sender Wink Start)

2.When the number of the digits for an originating call specified by the NND parameter is dialed, the following occurs at the same time.

(a)The SND circuit starts to transmit the number information to the external trunk route.

(b)The Originating Register (ORT) circuit is released.

3.The NND parameter assigned by this command determines the number of necessary digits to be received by the originating register (ORT) circuit.

4.The data entered in NND parameter should include the number of digits of the trunk access code.

3.Data Entry Instructions

IC/OG

I= Incoming (Not used) O = Outgoing

NND

Enter desired number of necessary digits.

LOGICAL ROUTE	INCOMING/	NUMBER OF
NUMBER	OUTGOING	NECESSARY	REMARKS
(LGRT)	CALL	DIGITS
1-899	(IC/OG) I/O	(NND) 1-24

CHAPTER 4 NDA-24298

Page 276

Issue 1