NEC NDA-24298 manual Operator Call Hooking Busy

ASPAL : Assignment of Special Access Code for LDM

4.Data Sheet

(a)Service Code (SRV = SSC)

TENANT	ACCESS CODE			CONNECTION		KIND OF	SERVICE	NUMBER OF
			(ACC)				FEATURE	NECESSARY
NUMBER				STATUS INDEX		SERVICE			SERVICE CONTENTS
		MAXIMUM					INDEX	DIGITS
(TN)					(CI) N/H/B	(SRV)
		6 DIGITS					(SID) 1– 63	(NND) Note 1
				H	Hooking	SSC	1		Call Hold
				N	Normal	SSC	2		Dial Access to Attendant
									(Operator Call)	Note 4
				H	Hooking
				B	Busy	SSC	3		Call Back; Entry
				H	Hooking				Camp on By Station
				B	Busy	SSC	4		Executive Right of Way
				N	Normal	SSC	5		Call Waiting – Originating
				B	Busy
				N	Normal	SSC	6		Call Back; Cancel
							7		Not used
				N	Normal	SSC	8		C.F. – All Calls/Split C.F. –
									All Calls; Entry	Note 2
				N	Normal	SSC	9		C.F. – All Calls/Split C.F. –
									All Calls; Cancel	Note 2
				N	Normal	SSC	10		C.F. – Busy Line/Split C.F.
									– Busy Line; Entry Note 2
					Normal				C.F. – Busy Line/Split C.F.
				N		SSC	11		– Busy Line; Cancel
									Note 2
					Normal				C.F. – Don’t Answer/Split
				N		SSC	12		C.F. – Don’t Answer; Entry
									Note 2
					Normal				C.F. – Don’t Answer/Split
				N		SSC	13		C.F. – Don’t Answer;
									Cancel	Note 2
				N	Normal	SSC	14		Speed Calling – Station;
									Entry
				N	Normal	SSC	15		Speed Calling – System;
									Access	Note 3
							16		Not used
				N	Normal	SSC	17		Individual Trunk Access
							18		Not used

Note 1: The parameter may vary depending on the service.

Note 2: When Split Call Forwarding is in service (the command ASYD, SYS1, INDEX79, bit2=1), this access code is used for Split Call Forwarding.

Note 3: When Speed Calling-System; Access is assigned, NND1 parameter assignment is required in addition to the NND parameter.

Note 4: Fill in the FPC in place of the parameter NND.

NDA-24298CHAPTER 4

Page 245

Issue 1