NEC NDA-24298 manual Smdr Control Circuit Card Designation

ASYD : Assignment of System Data

	SYSTEM	DATA		BIT
SYSTEM				CORRESPONDING
	DATA	(DATA)
DATA				DATA
	INDEX	00	– FF			SYSTEM DATA CONTENTS
TYPE
	(INDEX)	(Hex)		DATA
(SYS)
	0 – 511				BIT
				0/1
				0	b0
				0	b1
				0	b2	Not used

0b3

0b4

67	00
			b5
		0
	0		b6	SMDR Control Circuit Card Designation
				0/1 = MRC/SMDC (Always assign “0.”)
	0		b7	SMDR Sending Designation
				0/1 = AP/SMDC (Always assign “0.”)
				Operating method for busy station service (Call back, Executive
			b0	Right of Way, etc.)
				0/1 = SHF + Access Code/Last Digit + Access Code
				Operating method for Individual Trunk Access (ATT) service
			b1	0 = Route No. + Trunk No.
				1 = C.O. Code (as assigned via command ACOC)
1
			b2	Ringing Signal type forTAS indicator
				0/1 = Interval/Continuous
			b3	OG Trunk Queuing (On-Hook) Automatic Cancel
				0/1 = Out/In Service
				TKSL key on the Attendant Console (for Individual Trunk Ac-
68			b4	cess service)

		0/1 = Out/In service
0	b5	Not used
	b6	Ground Button (GB) used for SHF
		0/1 = Not Required/Required
		OG call operation			Used only for
		–	via Attendant	Direct Dial	Special
		b7	Console	Access	Common
	b7	0	Off-Hook	Off-Hook by	Battery
					Telephones
				pressing GB
		1	Off-Hook by	Off-Hook
			pressing GB
CHAPTER 4		NDA-24298
Page 86
Issue 1