NEC NDA-24298 manual Artdn Assignment of Route Class Data for NDM

ARTDN : Assignment of Route Class Data for NDM

ARTDN: Assignment of Route Class Data for NDM

1.General

Using this command, all logical route data of all Local Node (LN) may be displayed and changed at the Network Control Node in the Fusion network.

2.Precautions

1.The ARTDN command should be assigned for all logical trunk routes and the logical dummy route for LCR/LCRS.

2.The Logical Route Class data assigned by this command is also allocated to Route Class data (ARTD). If the Logical Route Class data is deleted by using this command, however, the Route Class data is not to be deleted. Therefore, use ARTD command to invalidate the Route Class data.

3.The standard route class data is shown in the example, which is listed after the parameter descriptions.

4.Parameters TCMN through MT are effective only when 4 (MF) is assigned to parameter ONSG or INSG. For all other logical trunk routes, assign “0” to all of these data.

3.Data Entry Instructions

See data sheet in Section 4.

NDA-24298CHAPTER 4

Page 535

Issue 1