NEC NDA-24298 manual Adrtl Assignment of Dterm Display Route Data for LDM

ADRTL : Assignment of Dterm Display Route Data for LDM

ADRTL: Assignment of Dterm Display Route Data for LDM

1.General

This command changes the display of trunk class information on the Dterm instead of the Trunk Class (TCL) designation of the ARTD command.

2.Precautions

1.The data assigned in this command affects the stand alone-node and Local Node (LN).

2.When this data is assigned to Local Data Memory (LDM) in the Fusion Network, if Network Data Memory (NDM) has Display Route Data designated by the ADRTN commands, NDM data overrides LDM data.

3.The data assigned by this command is not available for ISDN stations and PS.

4.When a call terminated from the trunk COC number has been assigned by the ACOC command, the following is displayed on the Dterm as to “TYPE” parameter;

•TYPE = 1 (4 characters) is entered, both COC number assigned by the ACOC command and 4- character trunk class assigned at “DISP” parameter is displayed.

•TYPE = 2 (8 characters) is entered, only the 8-character trunk class assigned at “DISP” parameter is displayed.

3. Data Entry Instructions

RT

Assign Physical Route number at the non-Fusion node.

Note: For Fusion node, assign Logical Route number using the ADRTN command.

DISP

The characters displayed on the Dterm.

Route

Number

(RT)

Character

Display Type

(TYPE)

1, 2

Display for Trunk Class on Dterm

(DISP)

REMARKS

TYPE

The maximum number of characters 1 = 4 (4 bytes ASCII characters)

2 = 8 (8 bytes ASCII characters)

CHAPTER 4 NDA-24298

Page 476

Issue 1