NEC NDA-24298 manual Akydt Assignment of Key Data for Dterm Telephone Number

AKYD_T : Assignment of Key Data for Dterm – Telephone Number

AKYD_T: Assignment of Key Data for Dterm – Telephone Number

1.General

This command assigns the Line Key, Function Key, Intercom Key, and DSS Key data corresponding to each line/feature button on a Dterm. The station data of AKYD command can be assigned by using Telephone Number.

2.Precautions

1.Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the ALGSL command is not available in this command.

2.In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in node can be used in this command. Also, when logging in to the NCN, the data memory of the whole nodes in the network is to be written.

3.Prior to this command, Telephone Numbers must be allocated by using the ALGSN command. Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the ALGSL command is not available in this command.

4.The Dterm series III (16-button type) and Dterm series E have the default key data. (Refer to Precautions 8.)

If the default data is to be used, assignment in AKYD/AKYD_T is not necessary. The table below shows the specification pertaining to data assignment for the Dterm.

Table 4-14 Data Assignment for the Dterm

TYPE OF Dterm		LINE/FEATURE BUTTON	NUMBER OF BUTTONS
	8-button type	KYN = 1-8	8
Series III	16-button type	KYN = 1-16	16
	24-button type	KYN = 1-24	24
	8-button type	KYN = 1-8	8
Series E	16-button type	KYN = 1-16	16
	32-button type	See Figure 4-7	32

5.Before assigning the key data for a Dterm using this command, be sure to assign the station data of the Dterm using the ASDT command (TN, STN, TEC = 12 (Dterm)). The station number assigned by the

ASDT command is referred to as “MY LINE”. Note

Note: This “MY LINE” corresponds to the physical port associated with the LENS of a ELC card.

6.By assigning another station line to a feature button using this command, an incoming call terminated to a station line other than My Line can be answered or can be transferred to elsewhere as in the case of the My

Line. A station line other than My Line is referred to as a “Sub Line.” A “Sub Line” can be assigned not only to a Dterm but to any conventional telephone. In addition, the station data for My Line and Sub Line

must be assigned by the ASDT command before the key data is assigned. When the Sub Line and the My Line belong to different tenants, use the ATNR command and clear the “Tenant-to-Tenant Restriction.”

NDA-24298CHAPTER 4

Page 453

Issue 1