NEC NDA-24298 manual Aopr Assignment of Outgoing Pattern Routing Data

AOPR : Assignment of Outgoing Pattern Routing Data

AOPR: Assignment of Outgoing Pattern Routing Data

1.General

This command assigns the LCR/LCRS routing pattern for each Outgoing Route Selection Pattern Routing (OPR) number.

2.Precautions

1.The OPR parameter corresponds to the one assigned by the AFRS command.

2.The TDPTN parameter is intermediate data to assign the ATCP command. The ATCP command is used to assign the time pattern.

3.The PNL parameter is intermediate data to assign the AADC command. The AADC command is used to assign the additional numbers to transmit.

4.The applicable number of additional digits (DC) by the AADC command varies depending on the PNL data. A maximum of 4 digits of DC is available when the PNL is assigned the range from 1 to 127, and the maximum of 24 digits of DC is available when the PNL is assigned the range from 128 to 999.

5.The E parameter is an indicator label of the RA. When E=1 is assigned, more RA assignments are required until E=0 has been assigned.

6.The overflow tone can be applied to the originating party if an alternate trunk route has been seized. The OVFT parameter designates whether the overflow tone is or is not provided.

7.The PRSC parameter is referred to as RSC2 of the AEFR command if the LCR-Controlled Alternate PRSC service is provided. Enter 0 (leave it blank) when the service is not required.

CHAPTER 4 NDA-24298

Page 308

Issue 1