NEC NDA-24298 manual Adimt Assignment of Dial Intercom Data Telephone Number

ADIM_T : Assignment of Dial Intercom Data – Telephone Number

ADIM_T : Assignment of Dial Intercom Data – Telephone Number

1.General

This command is used to assign Dial Intercom service related data. The station data of ADIM command can be assigned by using Telephone Number instead.

2.Precautions

1.Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the ALGSL command is not available in this command.

2.In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in node can be used in this command. Also, when logging in to the NCN, the data memory of the whole nodes in the network can be written.

3.To provide Dial Intercom Service, it is necessary to assign the following data in advance: ASYD command, SYS1, INDEX 59, b7=1

4.The number of Dterm stations that can be accommodated in a Dial Intercom Group and also the number of digit for Call Number (Dial Intercom STN) are determined by parameter N (Dial Intercom Digit Number).

5.When N=0 is entered, a maximum of 10 Intercom Station Numbers can be assigned. When N=1 is entered, a maximum of 64 Intercom Station Numbers can be assigned.

6.The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX 8.

7.Enter “My Line” Station Number of Dterm in the ICMSTN (Dial Intercom Station Number) parameter.

8.Compose a Dial Intercom Group with Dterm stations of the same Tenant Number (TN) under the same Module Group (MG).

9.From 1 to 50 Dial Intercom Groups can be composed on each Module Group (MG) basis.

10.An Intercom member can override another Intercom station in a two-party Intercom connection. This kind of overriding is referred to as INTERCOM BRIDGE.

NDA-24298CHAPTER 4

Page 489

Issue 1