NEC NDA-24298 manual Anddt Assignment of Name Display Data Telephone Number

ANDD_T : Assignment of Name Display Data – Telephone Number

ANDD_T : Assignment of Name Display Data – Telephone Number

1.General

This command is used to assign user information (user’s name) onto a Station to program the Name Display - System service feature. The station data of ANDD command can be assigned by using Telephone Number.

2.Precautions

1.Only the Telephone Numbers assigned by the ALGSN command can be used. Telephone Numbers by the ALGSL command is not available in this command.

2.In case logging in to a LN, only the Telephone Numbers allocated to the stations within the logged-in node can be used in this command. Also, when logging in to the NCN, the data memory of the whole nodes in the network can be written.

3.The Name Display - System service feature allows a Dterm with LCD to show the user information that corresponds to the calling station number while it is engaged in a station-to-station call.

4.The ASYD command SYS1, INDEX78, b5=1 (Name Display service) must be set.

5.The number of digit to be assigned to the parameter NAME is determined by the ASYD command, SYS1, INDEX241, b1=0/1: 8 characters/16 characters. Multi-Line service is not available if “16 characters” is selected.

6.This command cannot be used for Name Display - OAI service.

7.The applicable tenant number (TN) range is designated by the ASYD command, SYS1, INDEX 8.

8.This command is an available software enhancement.

3.Data Entry Instruction

TELN

Enter the Telephone Number of the station to which Name Display service is to be applied.

USER	TELEPHONE NUMBER	NAME DISPLAY INFORMATION
GROUP
	(TELN)	(NAME)	REMARKS
NUMBER
	Max. 16 digits	8 or 16 characters
(UGN)
		NAME

Enter desired alphanumeric characters.

Note: The existing data can be readout by pressing “Get” button after UGN and TELN data is entered.

NDA-24298CHAPTER 4

Page 429

Issue 1