NEC NDA-24298 manual Station Controlled Conference

ASYD : Assignment of System Data

	SYSTEM			BIT
SYSTEM		DATA	CORRESPONDING
	DATA
DATA		(DATA)		DATA
	INDEX					SYSTEM DATA CONTENTS
TYPE		00 – FF
(SYS)	(INDEX)	(Hex)	DATA
	0 – 511				BIT
			0/1
			0		b0	Not used
						Restriction in the number of outside parties who can participate
						in the Station Controlled Conference.
						0/1 = Not Required/Required
						If “0” is set, the outside party who can participate in the Station-
						Controlled Conference is as follows:
					b1	(a) For Tie Lines, it is possible to call a maximum of seven
						lines, as long as the distant PBX returns the answer
						signal and release signal.
						(b) For C.O. Lines, answer signal and release signal are not
						necessary. Only one C.O. LINE can attend the
						conference.
						If “1” is set, only one outside party can participate in the Station-
						Controlled conference.
			0		b2	Not used
	7
			0		b3
						Ability to camp-on indication for Attendant Console
1			0		b4	0/1 = Normal/Busy LED flashes and Attendant Console hears
						ROT if unable to camp-on
						Processing of the following conditions in Automated Attendant
						Service:
						• When a trunk party has dialed an unused number or a dead
					b5	level
						• When a trunk party has abandoned dialing a Station Number
						• When a station is restricted from connection
						• When the calling station does not answer
						0/1 = Announcement is sent to the trunk party/Forced release
						Processing after PB Receiver Timeout in Automated Attendant
					b6	Service:
						0/1 = Forced release/Transfer to ATT (Normally, assign “0.”)
			0		b7	Not used
	8					Number of Tenants: 1-63 (= 01-3F [HEX.])
						Number of Attendant Consoles
	9					1IMG: 1~16 (01Hex~10Hex)
						4IMG: 1~60 (01Hex~3CHex)
						IPX-U (16IMG): 1~60 (01Hex~3CHex)

NDA-24298CHAPTER 4

Page 67

Issue 1