NEC NDA-24298 manual Arsc Assignment of Route Restriction Class, Rri, Descriptions

ARSC : Assignment of Route Restriction Class

ARSC: Assignment of Route Restriction Class

1.General

This command assigns route restriction information according to the Route Restriction Class (RSC) of the station and the Route Number (RT).

2.Precautions

1.Data can be entered on a Day/Night basis, if specified in ASYD command, SYS1, INDEX75, bit 0=1.

2.The applicable Tenant Number (TN) range is designated by the ASYD command, SYS1, INDEX8. If data of this command is common for all tenants (ASYD command, SYS1, INDEX92, bit4=1), assign TN parameter as data “1” for all tenants.

3.The displayed Route Restriction Class (RSC) corresponds to the one assigned by the ASDT command.

4.The details of each RRI are as follows:

RRI	Descriptions
RRI-0	Trunk incoming connection with an Attendant Console (or a station) assistance.
RRI-1	Trunk incoming connection without assistance.
RRI-2	Trunk outgoing connection with an Attendant Console (or a station) assistance.
	Trunk outgoing connection without assistance.
RRI-3
	Note: For the dummy route, assign the data to RRI3 only.

5.The restriction data (RES) is entered in the text box where RSC and RRI cross.

6.When RES=2 is assigned in RRI=3, ATDP/AARP (Toll Restriction 3/6 digits) should be assigned to specify the connection allowed area.

7.The parameter RES = “2” (Toll Restriction is allowed) is valid only when the parameter RRI = “3” (OG Restriction Directly) is assigned.

NDA-24298CHAPTER 4

Page 361

Issue 1