NEC NDA-24298 manual BIT Corresponding

				ASYDL : Assignment of System Data into Local DM (LDM)
SYSTEM	SYSTEM	DATA		BIT
			CORRESPONDING
	DATA
DATA		(DATA)		DATA
	INDEX					SYSTEM DATA CONTENTS
TYPE		00 - FF
	(INDEX)
(SYS)		(Hex)	DATA		BIT
	512 - 1535
			0/1
						(For IPX-UMG system)
					b0	Periodic Refresh for office data copy	Note 1
						0/1 = Execute/Stop
						(For IPX-UMG system)
					b1	Partial copy every time office data is assigned
	805					0 = Execute	Note 1
						1 = Not execute (data copy is executed by CBCD
						command
						(For IPX-UMG system)
					b2	Information of office data copy condition	Note 1
						0/1 = -/Output System Message
			0		b3 ~ b7	Not used
	806-831					Not used
						Fusion Point Code (FPC) of the node connected with
1	832					Message Center (MC) in the same MC group
						FPC: 1 ~ 253 (01 Hex. ~ FD Hex)
						Note: Valid for software version 2 or later.
					b0	Interface type for MCI (Message Center Interface)
						0/1 = RS-232C interface/LAN interface	Note 2
					b1	MCI output text format
						0/1 = IMS (ICS) format/IPX format	Note 2
						The way to output the call information of LAN
					b2	Interface for MCI (when Max. 2 MCs are normally
	833					connected).
						0/1 = Dual Output/Single Output
						Output the System Message related to connection
					b3	down when the system changeover occurs on LAN
						Interface for MCI.
						0/1 = Invalid/Valid
					b4 ~ b7	Not used

Note 1: When office data is assigned by the MAT during IPX-UMG system is in operation, office data (DM/LDM/NDM) copy is executed from ACT side SP to ST-BY side SP/LP.

Every time office data is assigned by the MAT, the part of the data is copied to ST-BY side SP and each LP when ASYDL, INDEX805, b1=0. Also office data copy is to be executed when the following operation is performed:

•System Initialization

•Initialization for each Processor

•Execution of the CBCD command

Note 2: When ASYDL SYS1 INDEX833 b0 = 0 (RS-232C interface for MCI) is assigned, either ICS or IPX text format for MCI output can be selected in b1. When b0 = 1 (LAN interface for MCI) is assigned, b1 data must be fixed to data “1 = IPX format.”

NDA-24298CHAPTER 4

Page 187

Issue 1