NEC NDA-24298 manual Apad Assignment of PAD Data

APAD : Assignment of PAD Data

APAD: Assignment of PAD Data

1.General

This command assigns PAD control data for tandem connections, and trunk-to-station connections.

2.Precautions

When KIND = 2 (station) is designated, assign the dummy data to the parameter OGPAD.

3. Data Entry Instructions

KIND

The kinds of connections entered in this parameter are as follows: 1 = Tandem Connection

2 = Station

3 = Outgoing (Not used)

4 = Incoming (Not used)

DC

The assignment of this parameter is required only when KIND = 3 (Outgoing) is designated.

This data should be assigned by the AMND command.

ICPAD/OGPAD

0 = No APAD Setting

1-14 = Note1 15 = PAD OFF (0dB)

Note 1: Switch setting varies depending on the trunk circuit card. Refer to “Circuit Card Manual.”

KIND	INCOMING			OUTGOING				INCOM-	OUTGO-
OF				ROUTE			DIGIT CODE	ING	ING
	ROUTE					SFC		PAD
CONNEC				NUMBER			(DC)		PAD
	NUMBER					0-15		DATA
-TION				(OGRT)			MAXIMUM 24 DIGITS		DATA
		(ICRT)						(ICPAD)
(KIND)									(OGPAD)
1-4								1-15	1-15
1	9	0	1	1	0
2				1	1	4		81

SFC

This parameter is not required for the parameter KIND = 1 (Tandem Connec- tion).

ICPAD

ICPAD is not required when assigning KIND as 3 (Outgoing).

OGPAD

The parameter OGPAD is not required when assigning KIND as 4 (Incoming).

NDA-24298CHAPTER 4

Page 611

Issue 1