NEC NDA-24298 manual Mwd

AKYD_T : Assignment of Key Data for Dterm – Telephone Number

3. Data Entry Instructions

				PRI
	LINE PREFERENCE			L: As per Preference pattern when
PRI				the SPEAKER button is pressed.
	1	2	3
				D: Dial Intercom Line
0	L			(Ringing Station)
1	D	L		A: Automatic Intercom Line
2	A	L		(Ringing Station)
3	M	L		M: Manual Intercom Line
4	A	M	L	(Signaling Station)

ORG

This data is only available in case of LN PRE=1.

0 = Prime Line Preference

1 = Idle Line Preference

	MY LINE				ANS
			This data is only available in case of LN PRE=1.
USER
	TELEPHONE NUMBER		0	= Prime Line Preference
GROUP
NUMBER		(TELN)	1	= Incoming Line Preference
(UGN)			2	= Ringing Line Preference
PRIORITY OF		PRIME LINE
ANSWERING	USER GROUP
CALL		TELEPHONE NUMBER
(PRI)	NUMBER
		(PL TELN)
0-4	(PL UGN)

ALLOW OG	MESSAGE
FROM
	WAITING DATA
PRIME
	DISPLAY
LINE
	SELECTION
(S)
	(MWD)
0/1
	0/1

LINE

PREFERENCE

(LN PRE)

0/1

LINE

PREFERENCE FOR SPEAKER BUTTON (SPK)

0-3

LINE

PREFERENCE FOR ANSWER BUTTON (ANS)

0-2

LINE

PREFERENCE

FOR

OUT GOING

BUTTON

(ORG)

0/1

TYPE OF

DTERM

(TP)

0-3

S

OFF-HOOK suppression

0=No 1=Yes

MWD

0 = MW data display on the top line

1 = MW data display on the bottom line

LN PRE

0 = Prime Line pickup

1 = Customize (Line Preference data are to be set for the other buttons)

SPK

This data is only available in case of LN PRE =1 0 = Prime Line Preference

1 = Idle Line Preference

2 = Incoming Line Preference

3 = Ringing Line Preference

DATA

0

1

2

Note 1

3

Note 2

	TP
MEANING
Dterm Series III	Dterm Series E
8-button or 16-button type	8-button or 16-button type
24-button type or 16-button type	32-button type (with Add on Module)
with Add on Module
8/16-button type + FLEX keys	8/16-button type + FLEX keys
24-button type + FLEX keys or	32-button type (with Add on Module)
16-button type with Add on Module	+ FLEX Keys
+ FLEX keys

The data assigned to the parameter “TP” may differ depending on the parameter “KYI”, or “KYI2”. See the below.

Note 1: When no data is assigned to KYN2, the system recognizes as TP=0.

Note 2: (1) When no data is assigned to KYN=17 or later/KYN2, the sys- tem recognizes as TP=0.

(2)When data is assigned to KYN=17 or later and no data is assigned to

KYN2, the system recognizes as

TP=1.

NDA-24298CHAPTER 4

Page 457

Issue 1