NEC NDA-24298 manual 511

ASYD : Assignment of System Data

	SYSTEM				BIT
SYSTEM			DATA	CORRESPONDING
	DATA
DATA			(DATA)		DATA
	INDEX						SYSTEM DATA CONTENTS
TYPE			00 – FF
(SYS)	(INDEX)		(Hex)	DATA
	0	– 511				BIT
				0/1
				0		b0
				0		b1
				0		b2
				0		b3	Not used
		116		0		b4
				0		b5
				0		b6
							Password Function (Effective only		Data for Port 0 of the
						b7	with MAT)
									IOC Circuit Card
							0/1 = Out/In Service	Note 1
1
				0		b0
				0		b1
				0		b2
				0		b3	Not used
		117		0		b4
				0		b5
				0		b6
							Password Function (Effective only		Data for Port 1 for the
				0		b7	with MAT)
									IOC Circuit Card
							0/1 = Out/In Service	Note 2

Note 1: When setting the data that designates Print/Message Center and MAT, be sure the data is not duplicated in the Port number data to be assigned by SYS-1, INDEX 288, 290, 292, and 294. Also, when setting the data that designates SMDR, it is necessary to assign the corresponding data to SYS-1, INDEX 288, 290, 292, and 294.

Note 2: Bits 0 ~ 6 are assigned in the AIOC command. Only bit 7 may be changed using this index.

Note 3: When activating the Password function, assign “b7 = 1" ONLY after a Password Code has been assigned using the command APSW.

CHAPTER 4 NDA-24298

Page 102

Issue 1