NEC NDA-24298 Atnr Assignment of Tenant Restriction Class Data, Tri, TRI Objective Situation

ATNR : Assignment of Tenant Restriction Class Data

ATNR: Assignment of Tenant Restriction Class Data

1.General

This command assigns the tenant restriction data for each objective situation.

2.Precautions

1.Data can be entered on a Day/Night basis, if specified in ASYD command, SYS1, INDEX75, bit 2=1.

2.The applicable Tenant Number (TN) range is designated by the ASYD command, SYS1, INDEX8.

If data for this command is common for all tenants (ASYD command, SYS1, INDEX 94, bit0=1), assign TN parameter as data “1” for all tenants.

3.Table 4-9provides the Tenant Restriction Index (TRI) data. Since the OBJECTIVE SITUATION indi- cated as “-” may not always be the “Not used” index, do not enter RES=1 for “-” to prevent unexpected effects.

	Table 4-9 TRI
TRI	OBJECTIVE SITUATION
0	Station within OGTN calls to a station within TMTN
1	Station within OGTN sets Call Forwarding-All Calls / Busy Line / Don’t Answer to a station within TMTN
2	–
3	Attendant Console within OGTN sets Call Forwarding-All Calls for a station within TMTN (Call Forwarding -
	All Calls set/Cancel by ATT)
4	Station within OGTN call to an Attendant Console within TMTN by dialing individual ATT number assigned by
	the ASAT command
5	External Key within OGTN changes the Day/Night Mode of TMTN
6	–
7	Incoming call of the trunk within OGTN terminates to a station within TMTN (In the case of MFC signaling only)
8 - 15	–

NDA-24298CHAPTER 4

Page 405

Issue 1