NEC NDA-24298 manual Dialing Service

ACDD_LR : Assignment of Change Digit Code for Dial In Service – Logical Route Number

ACDD_LR: Assignment of Change Digit Code for Dial In Service – Logical Route Number

1.General

This command is used to assign the Change Digit Code for the ISDN line with DID Addressing. Route number of the ACDD command can be assigned by using Logical Route.

2.Precautions

1.Prior to this command, logical route data must be allocated by using the ALRTN command.

2.Only when logging in to the NCN (Network Control Node), this command can be used to assign the logical route data of self-Node and the other Nodes in the Fusion Network. If logging in to a LN (Local Node), data setting only for the self-node is available. (Error message is indicated if you try to write the data of other Node.)

3.Data can be entered on a Day/Night basis if specified in the ASYD command, SYS 1, INDEX 75, bit 5=1.

4.This command does not affect if DC = 0 (Sub Address - Addressing) is assigned by the ARTD command.

5.Enter the Logical Route Number of the B-channel route in the parameter “LGRT.”

3.Data Entry Instructions

D/N

•Day Mode

•Night Mode

DC

Number of digit for this DC must match the data in DC of the ARTD command.

XFR

Always select “In Service” at XFR parameter when ISDN DID Addressing is provided.

•In Service = Transfer is valid

•Out of Service = Transfer is invalid

DAY/

NIGHT MODE (D/N)

LOGICAL FUSION ROUTE POINT NUMBER CODE

(LGRT) (FPC)

1-899 1-253

EXTERNAL

ROUTE

NUMBER

(RT)

DIGIT CODE	CHANGE DIGIT CODE	ADDITIONAL	TRANSFER
(DC)	(CDC)
MAX. 7 DIGITS	MAX.24 DIGITS	DIALING	SERVICE
[0-9, *, #]	[0-9, *, #, P]	(AD)	(XER)

LGRT

Enter the Logical Route Number of the B-channel route.

AD

Always select “Out of Service” in AD parameter when ISDN DID Addressing.

•Out of Service = Additional Dialing Service is invalid

•In Service = PBX dial-in Additional Dialing Service (Japan) is valid

NDA-24298CHAPTER 4

Page 809

Issue 1