NEC NDA-24298 manual Atdpl Assignment of Toll Code Restriction Data for LDM

ATDPL : Assignment of Toll Code Restriction Data for LDM

ATDPL: Assignment of Toll Code Restriction Data for LDM

1.General

This command assigns the area code of Toll Restriction - 3/6 digits for an outgoing connection. This data is written in Local Data Memory (LDM). When using common Toll Code Restriction data in Fusion Network, assign this data via the ATDPN command.

2.Precautions

1.This command is used when restriction data is assigned to RES = 2 (Toll Restriction is required) in the ARSCL command or in the ARRCL command.

2.The office code following the area code assigned on this command can also be specified by the AARPL (LDM)/AARPN (NDM) command.

3.Setting Method of Area and Office Code Restriction

TRK
ACC		TOLL	AREA	OFFICE		STATION
CODE		CODE	CODE	CODE		NUMBER
9	–	1	– NPA –		Nxx –	xxxx

In case the number to be dialed is as shown above.

(a)3-Digit Toll Restriction

9 - 1 - NPA - Nxx - xxxx

A 3-digit toll restriction is a restriction that is to be executed by developing the contents (NPA in this case) of the digits that follow the toll code.

If the data is set as follows, a toll call can be restricted by developing NPA.

•At Toll Code Restriction Data for LDM (ATDPL) DC = 9-1, TDI = 2, NND = 3 (NPA)

•At Area & Office Code Data (AARPL) DC = NPA (Only 3 digits)

(b)6-Digit Toll Restriction

9 - 1 - NPA - Nxx - xxxx

A 6-digit toll restriction is a restriction that is to be executed by developing the contents (NPA - Nxx in this case) of the 6 digits that follow the toll code.

CHAPTER 4 NDA-24298

Page 376

Issue 1