NEC NDA-24298 manual Ancd Assignment of Night Connection Data, Mg/Ncu/Pkg, Port, Rt/Tk

ANCD : Assignment of Night Connection Data

ANCD: Assignment of Night Connection Data

1.General

This command is used when the Power Failure Transfer (PFT) circuit card is controlled by the external key.

2.Precautions

1.When the “PFT control by the external key” is required, the following data assignments are needed:

(a)AUNT command, TYPE = 2 (PFT)

(b)AEKD command

(c)ANCD command

(d)ACSI command, CSI = 4 (Direct-in Termination (Night Mode))

3.Data Entry Instructions

MG/NCU/PKG

Enter the data assigned by the AUNT command.

PORT

The port parameter corresponds to the circuit number of the PFT card.

MODULE	PFT CARD	PORT NUMBER	ROUTE	TRUNK	REMARKS
GROUP	NUMBER	OF PFT CARD	NUMBER	NUMBER
(MG)	(NCU PKG)	(PORT)	(RT)	(TK)
00-31	0-3	0-11	1-255

RT/TK

Enter the trunk route number (RT) and the trunk number (TK) connected to the corresponding circuit number of PFT card.

CHAPTER 4 NDA-24298

Page 766

Issue 1