NEC NDA-24298 manual Eqp

AAEDL : Assignment of Announcement Equipment Data for LDM

3. Data Entry Instructions

C

0=30 seconds, and then disconnects

1=The connection is held until the calling party released

R
	LGRT
0=Send RBT
1=Do not send RBT	Enter logical route number.

A

0=Answer Signal is not sent 1=Answer Signal is sent

TENANT	ANNOUNCEMENT	DURATION OF	SENDING	ANSWER	MULTIPLE	LOGICAL
				SIGNAL		ROUTE	TRUNK
NUMBER	EQUIPMENT	CONNECTION	RBT		CONNECTION
						NUMBER
(TN)	NUMBER	(C)	(R)	SENDING	(M)		NUMBER
						(LGRT)
	(EQP)0-127	0/1	0/1	(A)	0/1		(TK)
						1-899
				0/1

EQP

Enter EQP as the service feature provided by DAT.

0=Dead Level Number	Note: The EQP for Hotel system is
1=Unused Number
	changeable by the AHSY command,
2=Remote Access to PBX
	though the default EQP (service name)
3=May be used for other purposes
	are listed here.
4=Outgoing Trunk Busy Announcement
5-6=May be used for other purposes
7=Route Restriction Announcement
8-14=May be used for other purposes

15=Alert Service(for Hotel system) Note

16=Timed Reminder Set Message (for Business system)/ Service Set-up Message (for Hotel system) Note

17=Service Set-up Failure Message (for Hotel system) Note 18=Timed Reminder Cancel Message (for Business system)/

Service Cancel Message (for Hotel Massage) Note

19=Service Cancel Failure Message (for Hotel system)	Note
20=Room Cut-Off Announcement (for Hotel system)	Note
21=Do Not Disturb Announcement (for Hotel system)	Note

22=Timed Reminder/Wake Up Call Message for Announcement Trunk 23-31=Group Announcement (for Hotel system) Note

32=Delay Announcement-Attendant (for U.S.A./Canada only) 33=Not Used

34=Automated Attendant (1st Announcement) 35=Automated Attendant (2nd Announcement)

36=Slumber Time-Do Not Disturb (for Slumber Time Group 1) 37=Slumber Time-Do Not Disturb (for Slumber Time Group 2) 38=Slumber Time-Do Not Disturb (for Slumber Time Group 3) 39=Slumber Time-Do Not Disturb (for Slumber Time Group 4) 40=Slumber Time-Do Not Disturb (for Slumber Time Group 5) 41=Slumber Time-Do Not Disturb (for Slumber Time Group 6) 42=Slumber Time-Do Not Disturb (for Slumber Time Group 7)

43-48=Not Used

49-53=Delay Announcement Attendant (1st Announcement)

54-58=Delay Announcement Attendant (2nd Announcement)

59-121=Not Used

122-125=Multiple Announcement

126-127=Not used

M

0=Single connection 1=Multiple connection

TK

Enter TK data.

Note: This parameter appears if M=1 is entered.

NDA-24298CHAPTER 4

Page 619

Issue 1