NEC NDA-24298 manual Cdn

ACDN : Assignment of Number of Digits for Consecutive Dialing Data

ACDN: Assignment of Number of Digits for Consecutive Dialing Data

1.General

This command assigns the number of digits to be added to the access code of a distant office that has been assigned via the AMND command.

2.Precautions

1.The ARTD command is to be used to assign data “1” in the parameter CD prior to the operation of this command. It is also necessary to assign the distant office code via the AMND command prior to assigning the data for ACDN.

2.As far as tenants are concerned, the same conditions apply as in the AMND command. If the numbering plan is common for all tenants (ASYD, SYS1, INDEX 93, bit6=1), assign the TN parameter 1 for all tenants.

3.The applicable Tenant Number (TN) range is designated by the ASYD command, SYS 1, INDEX 8.

3.Data Entry Instructions

CDN

Enter the number of digits to be transmitted after the dialed number (Destination number).

TENANT NUMBER	DESTINATION CODE	NUMBER OF DIGITS OF	REMARKS
(TN)	(DC)	CONSECUTIVE DIALING
	MAXIMUM 10 DIGITS	(CDN)

DC

Enter the "access code + area/office code" (or its element) to be specified the necessary digits.

NDA-24298CHAPTER 4

Page 795

Issue 1