NEC NDA-24298 manual Assigned to parameter ADD

AAND_LR : Assignment of Automatic Number Identification Data – Logical Route Number

AAND_LR: Assignment of Automatic Number Identification Data – Logical Route Number

1.General

This command is used to assign ANI data for the number of digits of calling station number and the office code on each tenant basis for the Automatic Number Identification (ANI) service (for E911 ANI). Route number of the AAND command can be assigned by using Logical Route.

2.Precautions

1.Prior to this command, logical route data must be allocated by using the ALRTN command.

2.Only when logging in to the NCN (Network Control Node), this command can be used to assign the logical route data of self-Node and the other Nodes in the Fusion Network. If logging in to a LN (Local Node), data setting only for the self-node is available. (Error message is indicated if you try to write the data of other Node.)

3.The Route number of RT parameter should have been designated in ARTD, CDN19 ANI = 1.

3.Data Entry Instructions

AT

•STA outgoing

•ATT outgoing

DC

Office Code for the number of digits

LOGICAL		OUTSIDE	assigned to parameter ADD.
	FUSION POINT
ROUTE		ROUTE	STA/ATT
	CODE
NUMBER		NUMBER	OUTGOING
	(FPC)
(LGRT)		(RT)	(AT)
	1-253
1-899		1-

MAIN/	EXPANSION	CENTRAL OFFICE	STA	OFFICE	CALL
	OF STA				ORIGINATOR	OFFICE CODE
SATELLITE	NUMBER	CODE	NUMBER	CODE TO BE	DIGIT TO BE	(DC)
CENTRAL	LENGTH	(COC)	LENGTH	ADDED	SKIPPED	MAX. 10 DIGITS
(CC)	(KT)	MAX. 5 DIGITS	(STNL)	(ADD)	(SKIP)	[0-9, *, #]
	OFF/ON		1-8	1-10	0-10

CC

•Main Central

•Satellite Central

These parameters vary depending on the assignment of the previous parameter.

CHAPTER 4 NDA-24298

Page 778

Issue 1